carton sealer is sealing machine above the main sealing parts, for this part if failure problems and we have no way to seal box, but on this component failure, how should we regulate it?

(a) to adjust the box cutter

Spring adjustment has three holes and adjust these holes can adjust the blade spring speed; long stretching rod length of tape, pull a retraction rod for adjusting of the rubber belt with a short by adjusting the length of the tool; blade adjustment to an appropriate height, so that the carton after sealing device wheel just press the carton on the angle of a set, at this time must knife blade synchronous to cut off the adhesive tape.
(b) before and after the adjustment of belt wheel synchronous depth
With the hand to push the limit to the eye side, the rear wheel is the same knife seat from 2 to 3mm for the correct position.
(c) adjust the friction brake
The elastic nut is rotated in a clockwise direction, which can increase the friction brake to reduce the adhesive tape cut off.
(d) adjust the tape device

Will be sealed box carton on the sealing position, and will the center of the carton and seal in the center of the box device of positive, mounted on the first tape and push in place, pine nuts, then use hexagon wrench, to clockwise or counterclockwise rotation until the tape was located on the centerline, locking nut.